静载

na.【力】dead load; quiescent load

网络释义：Static load; Static Loads; dl

网络释义

na.1.【力】dead load; quiescent load; static load

1.dead load Datam Ievel 基准面; Dead Load 静载, 自重; Delay Line 延迟线; ...

2.Static load 风化软岩 weathering soft rock 静载 static load 动载 dynamic load ...

3.quiescent load quick-speed steel 高速钢 quiescent load 静（荷）载 quiescent period 纯沸腾期 ...

4.Static Loads IFC 国际金融公司 dl 静载, 自重 AGN 营养咨询小组 ...

6.Statical Test. ... Walkway/Maintenance platform 走台/维修平台 1. Statical Test. 静载 2. Dynamic Test. 动载 ...

1.Static test and finite element analysis indicate that this strain multiplier have the advantage of good linear response.静载实验和有限元分析表明，这种应变倍增器具有良好的线性响应。

2.On the static loading test, to obtain a more precise result, the HJ series of concrete sensor was used to measure concrete crack width.在静载试验中对混凝土裂缝宽度的量测采用HJ系列混凝应变计，获得了较精确的试验结果。

3.Determining soil calculation parameters is one of key problems in numerical simulation of single pile static test.单桩静载试验数值模拟的关键问题之一是确定各土层的计算参数。

4.However, the propagating rate of weld metal will decrease with the increase in stress ratio under dead load and constant maximum loa. . .在静载和最大载荷一定的情况下，随应力比增大，焊缝的扩展速率降低。

5.During the simulation, the paper simulates the actual situation as more uniform as possible with static load and dynamic load.在数值模拟过程中采用了静载和动载两种方式，以期最大程度接近实际情况。

6.The contrast result show that the method given in this thesis is available. Thus, it offer a new method to inspect the compound foundation.通过与静载试验结果进行对比，证明了该方法的有效性，从而为复合地基的检测提供了一种新的途径。

7.Under the provisions of prestressed concrete pipe must be the quality of sampling, can be used static, dynamic load and other methods.根据有关规定，预应力管桩必须进行质量抽检，可采用静载、动载等方法。

8.Under the joint actions of the dead-load and repetitive loading, many concrete bridges suffered different degrees of fatigue issues.由于受到静载和重复荷载的共同作用，诸多混凝土桥梁出现了不同程度的疲劳性问题。

9.A static test is a non-operational test performed by simply applying a specified load to the hoist being tested.静载试验即直接加载一定重量的负载给被测试的葫芦。

10.By comparison with the dead-load test, the reliability of the new method was verified.通过工程实例，将计算值同静载试验值进行对比，证明了其可靠性。